15
Selecting and Affixing the Respective ID Label
Select the respective metrology ID label according to the accuracy class of
your choice and affix it to the platform to be verified.
Pin Assignment Chart for the RS-485 Interface
Cable length: 3 m (approx. 10 ft.)
Male connector:
Type C091D, 12-pin round connector with threaded locking ring, Amphenol
(IP65)
A RxD-TxD-N
B Not connected
C Not connected
D Not connected
E Signal GND
F Menu access switch for calibration/adjustment
(routed externally)
G VCC (24V power supply)
H Not connected
J GND (24V power supply)
K GND (24V power supply)
L RxD-TxD-P
M VCC (24V power supply)
Pin Assignments/Interface Connector
(Recommended):
Type C091D, 12-pin, Amphenol (IP65)
Type of cable: AWG 24 specification
Be sure to follow the instructions above for connecting the weighing platform
to the power supply!
Specifications Chards
To Next Page
Loading...
