Care and Maintenance
150
Service
Regular servicing by a Sartorius
technician will extend the service life of
your balance and ensure its continued
weighing accuracy. Sartorius can offer
you service contracts, with your choice
of regular maintenance intervals
ranging from 1 month to 2 years.
The frequency of maintenance intervals
depends on the operating conditions
and your tolerance requirements.
Repairs
Repair work must be performed by
trained service technicians. Any attempt
by untrained persons to perform repairs
may lead to hazards for the user.
!Warning!
Particles drawn in by the fan can build
up inside the balance housing. If you
are using this balance in the chemical
industry, be sure to handle or treat
defective parts of the balance or those
to be cleaned according to your country’s
current rules and regulations.
Cleaning
!Make sure that no dust or liquid enters
the balance housing
!Do not use any aggressive cleaning
agents (solvents or similar agents)
§ Unplug the AC adapter from the wall
outlet (mains supply)
§ If you have a data cable connected
to the interface, unplug it from the bal-
ance
§ Carefully remove any sample residue/
spilled powder using a brush or a
hand-held vacuum cleaner
§ Clean the balance using a piece of
cloth which has been wet with a mild
detergent
§ Use a commercially available glass
cleaning agent to clean the draft shield
doors
§ After cleaning, wipe down the balance
with a soft, dry cloth
Cleaning the Weighing Chamber
on ME215/235/254/414/614/36S
§ Slide the draft shield doors back as far
as they will go
To remove the weighing pan and clean:
§ Reach under the shield plate and lift it
together with the weighing pan off the
base to avoid damaging the weighing
system.
!Make sure that no dust or liquid enters
the balance housing
§ Carefully remove spilled powder from
the weighing chamber using a small car
vacuum cleaner with a mini-hose
attached
§ To remove liquid spills, use blotting
paper
To Next Page
Loading...
