$ The balance must be disconnected from power before preparing it for shipment.
Disconnect the AC adapter and all interface cables from the balance.
Transport Over Short Distances
§ Place one hand under the display and control unit and the other under the back of the
balance. Lift the balance carefully and carry it to the new location.
$ Avoid subjecting the balance to vibration or shocks (impact).
! Do not lift the balance by the draft shield or the front panel, as this can result
in damage.
Transport or Shipping Over Long Distances
Make sure you use all components of the original packaging in the following cases:
– for transport or shipping over long distances.
– if it is not certain that the balance will remain upright during transport or shipping.
§ Remove the following parts:
– Shield disk (included with ME235S/P models only)
– Weighing pan and shield plate:
Reach beneath the shield plate and lift it carefully, together with the weighing pan,
to avoid damaging the weighing system.
§ Open the draft shield doors and carefully position the balance in the lower packaging.
§ Press the foam padding against the housing.
20
Shipping the Balance
To Next Page
Loading...
