This balance complies with the
European Council Directives as well as
international regulations and
standards for electrical equipment,
electromagnetic compatibility, and
the stipulated safety requirements.
Improper use or handling, however,
can result in damage and/or injury.
Read these operating instructions
thoroughly before using your
balance to prevent damage to the
equipment. Keep these instructions in
a safe place.
Follow the instructions below
to ensure safe and trouble-free
operation of your balance:
!
Do not operate in a hazardous
area/location
!
Make sure that the voltage rating
printed on the AC adapter is identical
to your local line voltage
!
If you use electrical equipment in
installations and under ambient
conditions requiring higher safety
standards, you must comply with the
provisions as specified in the appli-
cable regulations for installation in
your country.
! Exposure to excessive electromagnet-
ic interference can cause the readout
value to change. Once the distur-
bance has ceased, the instrument can
be used again in accordance with its
intended purpose.
– The only way to switch the power off
completely is to disconnect
the AC adapter
– The balance housing is protected
against the penetration of solid objects
with a diameter of more than 2.5 mm
(such as accumulated dust) and
dripping water falling vertically (IP32) –
the housing is not completely dust-
and leak-tight, however
– Protect the AC adapter from contact
with liquid
– Note on Installation:
The operator shall be responsible for
any modifications to Sartorius equip-
ment and for any connections of cables
or equipment not supplied by Sartorius
and must check and, if necessary,
correct these modifications and connec-
tions. On request, Sartorius will provide
information on the minimum operating
specifications (in accordance with the
Standards listed above for defined
immunity to interference).
– Connect only Sartorius accessories and
options, as these are optimally designed
for use with your balance
When cleaning your balance, make
sure that no liquid enters the balance
housing; use only a slightly moistened
cloth to clean the balance.
Do not open the balance housing.
If the seal is broken, this will result in
forfeiture of all claims under the
manufacturer‘s warranty.
In case you have any trouble with your
balance:
$ contact your local Sartorius office,
dealer or service center
4
Warning and Safety Instructions
To Next Page
Loading...
