46
Keys
You can assign different functions to
the c key for deleting input and
applications.
When you delete applications, you can
delete either the data stored for all
applications or just selected data.
CF function
in application
When you delete input, you can either
delete all the data input in a field, or
only the last character entered.
CF function for inputs
You can block key functions; you can
choose whether to block all keys (except
e, s, draft shield left/right and
ionizer) or just the alphanumeric keys.
Block key functions
Extra Functions
Acoustic Signal
An acoustic signal is emitted when
you press a key. When the key pressed
is allowed, the signal is a single beep-
tone; when it is not allowed, this is sig-
naled by a double-beep (key does not
initiate a function). In the Setup menu,
you can configure whether
– the acoustic signal should sound (
On)
– the acoustic signal should not sound
(
Off)
Power-On Mode
You can configure the balance so that
when a power supply is connected,
– the balance is off
(
Off/on/standby or
Off/on)
– the balance switches on automatically
(
Auto on)
You can also set the configurations so
that when the balance is turned off
after use, it is
– off (
Off/on)
– in the standby mode
(
Off/on/standby)
After you turn on the balance,
a self-test of the functions is run
(
TEST is displayed in the text line;
the bar graph is shown)
46
Control Port Function
You can connect either a checkweighing
display or an external universal switch to
the serial communications port on the
balance (factory setting).
To do so, you need to configure the
interface for
input or output.
Pin Assignment Chart of the Female
Interface Connector
Pin Function: Input
15 p/r key; see
“Universal switch”
16 Left K key
17 Soft key 6 (Cal) j
18 Soft key 1 (F)
19 t key
Pin Function: Output
15 “External switch”
(see above)
16 Control port 1: lighter
17 Control port 2: equal
18 Control port 3: heavier
19 Control port 4: “set”
For further information on the
pin assignment chart, see the section on
“Pin Assignment Charts” in the chapter
entitled “Overview”.
Display
You can configure the display for your
individual needs.
The contrast can be adjusted in 5 levels:
Contrast
Characters can be displayed in black on
white or vice versa:
Background
You can blank out either the bar graph or
the text line or both
Digit size
10mm + bar graph
+ text display
13mm + bar graph
13mm + text display
13mm
You can blank out the display of
application symbols
Application symbols
To Next Page
Loading...
