Sartorius MSA6.6S - Execute Task: Parts Counting with Piece Weight Calculation

114 Cubis MSA User Manual
Parts Counting
t Define the accuracy to be used for the weight value.
#VPQTOCNTGUQNWVKQP: As displayed
HQNFFGERNCEG With one decimal place more than in the display
HQNFFGERNCEGUWith two decimal places more than in the display
Only with calculation of piece weight:
t Define whether or not the piece weight should be updated when counting.
1RVKOKUCVKQPQHH
$[RTGUUKPIMG[CHVGTRTQORV
#WVQOCVKEWRFCVKPI
y An overview of all settings is displayed.
t Check all settings and change as required.
y A message asks whether you would like to add another application.
t If required, select additional applications to be combined.
y Now you will be prompted to configure the weighing and printing functions.
t Check all settings and change as required.
t Enter a short name and a description for the new task.
t To save the new task, touch 5CXG.
Execute Task:
Parts Counting with Piece Weight Calculation
D t If you haven’t already done so, go to Application Management.
y The task selection is displayed.
t Touch the desired task.
or
t If the desired task is already selected, touch 5VCTV.
y The last used reference piece quantity P4GH is displayed.
t If you are working with a variable reference piece quantity, you must enter
or change this now.
t Place this exact amount (nRef) of the objects to be counted on to the
weighing pan.