Need help?Do you have a question about the Sartorius MSE224S and is the answer not in the manual?
General| Maximum Capacity | 220 g |
|---|---|
| Readability | 0.1 mg |
| Repeatability | 0.1 mg |
| Linearity | ± 0.2 mg |
| Pan Size | Ø 85 mm |
| Display | LCD |
| Calibration | Internal |
| Interface | RS232 |
| Operating Temperature | 10 °C to 30 °C |
| Operating Humidity | 15% to 80% (non-condensing) |
| Stabilization time (typical) | 2 seconds |
Warning about operating the equipment in explosive environments.
Warning about electrical hazards and proper usage.
Identifies hazards related to installation and operational use.
Instructions for connecting the weigh cell to the electronics module.
Ensuring the balance is level for accurate weighing.
Setup instructions for performing weighing below the balance.
Guidance on selecting a suitable location and setup conditions.
Instructions for connecting the balance to the power supply.
Step-by-step guide for manual balance leveling.
Ensuring the balance is level for accurate measurements.
How to perform a standard weighing operation.
Procedure for leveling the balance using the inclination sensor.
Procedures for calibrating and adjusting the balance for accuracy.
Details on the automatic calibration and adjustment feature.
Detailed procedure for internal calibration and adjustment.
A simplified step-by-step guide for initial weighing.
Steps for performing internal balance calibration.
Procedure for performing external calibration with weights.
Hierarchical overview of the balance's configuration menu.
A detailed overview of available parameter settings.
Configuration settings for various application programs.
Application for determining the density of solid materials.
Application for determining the number of parts with equal weight.
Step-by-step guide for using the Counting application.
Application to obtain weight readouts as a percentage of a reference.
Step-by-step guide for residual weight calculation.
Application for calculating weights using multipliers or divisors.
Step-by-step guide for calculating weight per unit area.
Application for determining weights of unstable samples via averaging.
Step-by-step guide for automatic animal weighing.
Application for weighing components to a defined total weight.
Step-by-step guide for formulation (counting parts into container).
Application to sum successive weight values exceeding balance capacity.
Step-by-step guide for totalizing weight values.
Application to change displayed weight units.
Step-by-step guide for density determination.
Step-by-step guide for mass unit conversion.
Connecting the balance to a PC via USB.
Diagram showing pin assignments for the 25-pin interface.
Parameters for configuring data output activation.
Sending control commands to the balance.
List and description of available SBI commands.
Information on the optional Bluetooth interface.
Step-by-step guide to connect the balance using a USB port.
Explains error messages and their corresponding codes.
Instructions for installing necessary software drivers.
Cleaning instructions for the weighing chamber of high-precision balances.
Checks to ensure the balance is safe to operate.
Instructions for cleaning the weighing pan.
General instructions and precautions for cleaning the balance.
Specifications for verified precision balance models.
To Next Page