16 EVO1Y | LAB1Y Operating Instructions
Installation
4 Installation
4.1 Unpacking and Equipment Supplied
t Open the packaging, making sure to remove all parts carefully.
t After unpacking the device, check it immediately for any external damage.
t If you detect any damage, proceed as directed in Chapter “7 Care and
Maintenance,” page 31.
t Save the box and all parts of the packaging for any future transport. All cables
should be unplugged when transporting.
The following parts are included in the equipment supplied:
Model PMA.Evolution PMA.HD
Large weighing pan: d 233 mm
x -
Small weighing pan: d 180 mm
- x
USB cable x x
AC adapter with country-specific mains adapter Optional Optional
Installation instructions x x
4.2 Selecting a Setup Location
Select the right setup location:
− Set up the device on a stable, even surface that is not exposed to vibrations.
− Maintain free access to the device at all times.
Choose a location that is not subject to the following negative influences:
− Heat (heater or direct sunlight)
− Drafts from open windows, AC systems and doors
− Extreme vibrations during weighing
− Heavy “traffic areas” (personnel)
Acclimatization
Condensation from humidity can form on the surfaces of a cold device when it
is brought into a warmer area. You should therefore let a device acclimatize for
approximately two hours disconnected from its power source before reconnecting
it to the supply voltage.
Seal on Scales Verified for Use in Legal Metrology:
Legislation requires that a seal be affixed to verified scales. On Sartorius devices,
this seal takes the form of a sticker with the “Sartorius” logo. If the seal is removed,
the validity of verification will become void and you must have your scale
re-verified. The declaration of conformity supplied here is for conformity-assessed
(verified) weighing instruments for use in the EEA. Please keep it in a safe place.
To Next Page
Loading...
