Need help?Do you have a question about the Sartorius PMA7500 and is the answer not in the manual?
General| Capacity | 7500 g |
|---|---|
| Readability | 0.1 g |
| Calibration | External |
| Display | LCD |
| Repeatability | 0.1 g |
| Linearity | ±0.2 g |
| Stabilization time (typical) | 2 seconds |
| Power Supply | AC adapter |
| Interface | RS232 |
Details different PMA7500 models and their variations.
Lists necessary special tools and software for service.
Mentions other relevant manuals for installation and operation.
Explains the purpose and operation of each key on the scale.
Describes how to access and navigate the scale's operating menu.
Step-by-step guide to enable Binary Processor Interface mode for service.
Outlines the order of calibration steps for the scale.
Details how to adjust the zero-point offset voltage using a DVM.
Procedure for verifying and correcting off-center load errors.
Instructions for adjusting scale linearity using service software.
Methods for performing span calibration via menu or service software.
Steps for replacing the main circuit board, including data backup.
Guide on how to safely open the scale housing for component access.
Procedure for replacing the display circuit board and connecting cable.
Steps for removing and installing a new strain-gauge load cell.
Lists display error codes, their causes, and recommended solutions.
Detailed breakdown of menu codes for scale functions and settings.
Technical specifications for reproducibility and off-center load tolerances.
Technical specifications for span adjustment and linearity tolerances.
Catalog of available spare parts for PMA7500 series models.
To Next Page