Universal Switch for Remote Control
You can connect an external universal switch to the interface of your scale for
remote control of certain functions listed below. Set the appropriate menu code
to define the function of this switch.
External key pad function Code Changes
p/p key (11) Data output 8 4 1 *
=/z key (14) Zero/tare 8 4 2
g/W key (13) Toggle between weighing/
counting or between ref./pc.ct 8 4 3
o/t key (22) Store in tare memory 8 4 4
u/w key (12) Start counting 8 4 5
z/T key (21) Start checkweighing 8 4 6
S/a key (19) Add to totalizing memory 8 4 7
Block all keys 8 4 8
Power-On Mode for QC Scales
The power-on mode can be set to meet your individual requirements. Your scale
recognizes the power source (line power or battery pack).
* = factory setting
2–17
Settings under Menu Code 8-5-x
Code 8-5-1 Code 8-5-2 Code 8-5-3 Code 8-5-4
Scale plugged in Scale plugged in Scale plugged in Scale plugged in
e/o key
e/o key e/o key
e/o key e/o key e/o key
Stand-by I
(only the e/o key
is active; electronics
are off)
Stand-by II
(only the e/o key
is active; electronics
are on, display not lit)
Scale in ready-to-
operate mode
When using a battery
pack, you can
also choose settings
8-6-3 and 8-7-1
To Next Page
Loading...
