Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during
alphanumeric input),
– printing (NUM print; S ID),
you can also access the following
functions from this application:
Calibration/Adjustment
● Press the
Cal soft key
> See “Calibration, Adjustment and
Linearization” for further instructions
Toggling to the Next Application
● Press d
> See the section on the
corresponding application program for
further instructions
Setup (Setting Parameters)
● Press s
> See “Configuring the Balance” for
further instructions
Turning Off the Balance
● Press e
> The balance shuts off
> The display goes blank, then standby or
off is displayed with backlighting
Example
Toggle the Display from Grams [g] (1st Unit) to Carats [ct] (2nd Unit)
Settings (changes in the factory settings required for this example):
Setup: Application parameters: Application 1: Toggle wt. units: Weight unit 2: Carats/ct
Step Press key(s) (or follow instructions) Display/Output
1. Toggle back to the basic unit c
(
(:Weight unit 1)
2. Change weight unit
ct soft key
to carats [ct]
(
):Weight unit 2)
3. Change weight unit
g soft key
to grams [g]
60
To Next Page
Loading...
