98
Preparation
● Turn on the balance: press e
> The Sartorius logo is displayed
● Select the Time-Controlled Functions application in the Setup menu: press s
● Select the
Application parameters: press the q key 2 x,
then the
O soft key
● Select
Application 2 (control functions):
press the
q soft key, then the O soft key
● Select
Time-controlled functions: press the Q or q soft key
● Confirm
Time-controlled functions: press the O soft key
Time-controlled Function after Beep
functions time interval Lock in readout
ο Automatic printout of values
Store value in applicat. 3 memory
Automatic function ο On
restart Off
Storage mode ο Without stability
After stability
After higher stability
Print then tare Off
ο On
ο = factory setting
see also the “Application Parameters (Overview)” in the chapter entitled
“Configuring the Balance”
● Save settings and exit the Setup menu: press the
oo soft key
Print Net Values without Printout of Time
Select the Setup menu:
Setup: Printout: Application-defined output: Auto print upon initialization: Off
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during alphanumeric input),
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
§ Press the
Cal soft key
> See “Calibration/Adjustment” for
further instructions
Toggling to Another Application
§ Press d
> See the section on the
corresponding application program
for further instructions
Setup (Setting Parameters)
§ Press s
> See “Configuring the Balance” for
further instructions
Turning Off the Balance
§ Press e
> The balance shuts off
> The display goes blank, then OFF or
Standby is displayed with backlighting
To Next Page
Loading...
