14
Basic Weighing Function
Features
– Taring the weigh cell
– Print weight value
Preparation
§ Switch on the weigh cell:
Press the e key
§ Tare the balance/scale, if necessary:
Press w
$ If necessary, change the configuration
settings:
see the chapter entitled “Configuration”
$ If desired, load the factory settings:
see the chapter entitled “Configuration”
Additional Functions:
$ Switching off the weigh cell:
Press e
Example:
Determine a weight value
Step Press key Display/Printout
1. Switch on the weigh cell:
e 0.0 g
Self-test runs
followed by automatic
initial tare function.
2. Place container on weighing pan
+ 11.5 g
(in this example 11.5 g).
3. Tare the weigh cell
w 0.0 g
4. Place sample in container + 132.0 g
(in this example 4.66 oz).
5. Print weight value r N + 132.0 g
To Next Page
Loading...
