10
Leveling the Weigh Cell in a Portable Weighing System (Leveling Feet Optional)
Purpose:
– To compensate for uneven areas at the place of installation.
– To ensure that the weigh cell is placed in a perfectly horizontal position for consistently
reproducible weighing results.
– Always level the weigh cell again any time after it has been moved to a different location.
§ Adjust the leveling feet until the air bubble is centered within the circle on the level
indicator.
Permanently Installed Weigh Cells
– Adjust the weigh cell after it has been installed in the system in its permanent
location – see next page.
The weigh cell must be calibrated/adjusted again any time its location or position
is changed.
– For optimum operation, install the weigh cell in a horizontal position.
1) Bottom plate of the weigh cell
2) Fastening frame of the system
§ Fastening with M6 screws:
Connection to the threaded fasteners on the weigh cell (1): torque 2.5 Nm
§ Fastening with M4 screws:
Connection to the threaded fasteners of a user-specific frame (2).
! Do not unscrew the sleeve.
1
1
2
2
To Next Page
Loading...
