43
Now follows the installation of the back part into the wall socket. For help use the picture below. Two
screws are attached for easier installation. Be careful to install the back part the right orientation as
the small “tongue” part
on the bottom should
be looking towards the
floor.
When you’ve attached the back part on the wall socket, you can connect the back part with the front
one. You can do that by carefully attaching the cable to
the front part and then pushing the front part of the case
on the already installed one. The thermostat should now
be installed and ready for use
Socket installation / »tongue« / Connecting cable / Screwing the back part in the socket
To Next Page
Loading...
