SATA Vision 2000 - Page 39

148
EN
Operating Instructions SATA vision 2000
Fitting new sweat band
■ Button the ve holes of the sweat band side into the lower ve holders
of the head band.
■ Pull the sweat band inwards over the foam strip.
■ Of the four remaining holes in the sweat band, button one each into the
upper holders on the right and left in the head band.
■ Align the sweat band so that the foam strip is completely covered.
■ Button the head/breast cloth into the upper holders on the right and left
of the head band to the sweat band.
10.8. Replacing foam strip behind the sweat band
Removing foam strip
■ Remove the sweat band (see chapter 10.7).
■ Pull the foam strip off the inside of the head band residue-free.
■ Remove any adhesive residues from the head band using a suitable
cleaning agent (see chapter 11.1).
Fitting new foam strip
■ Pull the protective lm off the adhesive tape of the foam strip.
■ Attach the foam strip to the inside of the head band in the middle (fore-
head part).
■ Fit the sweat band again (see chapter 10.7).
10.9. Replacing foam sleeve
Removing foam sleeve
■ Remove the hood inlay (see chapter 10.5).
■ Remove the air hose with foam sleeve [1-3], [2-3], [3-3] from the holder
in the base of the carrier frame.
■ Pull the warning whistle of the air hose [1-2], [2-2], [3-2] out of the bore
in the carrier frame.
■ Pull the foam sleeve off the air hose over the warning whistle.
Fitting the new foam sleeve
■ Push the new foam sleeve over the warning whistle onto the air hose so
that all air outlet slots are covered.
■ Thread the warning whistle of the air hose through the bore in the carri-
er frame.
■ Press the air hose with new foam sleeve into the holder in the base of
the carrier frame.