Satel AOD-210 - Installation

SATEL AOD-210 5
4 Installation
There is a danger of battery explosion when using a different battery than
recommended by the manufacturer, or handling the battery improperly.
Be particularly careful during installation and replacement of the battery. The
manufacturer is not liable for the consequences of incorrect installation of the
battery.
The used batteries must not be discarded, but should be disposed of in
accordance with the existing rules for environment protection.
If the detector is to be immune to the motion of pets, it should be mounted at
a height of 2.4 m without any vertical deflection. It must be borne in mind,
especially in the case of ball-type bracket mounting.
1. Remove the front cover (Fig. 4).
2. Install the battery and secure it with the clip you will find in the package.
3. Add the detector to the wireless system (see the ABAX 2 / ABAX controller manual or the
INTEGRA 128-WRL control panel installer manual). The sticker with serial number which
shall be entered when registering the detector in the system can be found on the
electronics module.
In the INTEGRA / VERSA alarm system, the detector is identified as AOD-200.
Simultaneous operation of the detector by the ABAX 2 and ABAX controller /
INTEGRA 128-WRL alarm control panel is not possible.