Satel CA-64 - Keypads

SYSTEM COMPONENTS
3
♦ 2 high-load outputs with electronic fuses for “power supply output” function.
♦ 2 connectors for voice synthesisers SM-2 or CA-64 SM.
♦ Communication bus for connection of LCD keypads; 8 LCD keypads and synoptic
table module may be connected to it.
♦ 2 buses for additional modules (expander rails), due to which 64 additional
modules may be connected to the control panel. Zone modules, output modules,
zone/output modules with power supply, partition keypads, coded locks, proximity
card readers and DALLAS chips and voice synthesisers may be connected to the
buses.
♦ Phone communicator, provided with a DTMF detection unit, enabling reception of
commands via the telephone, monitoring, information and remote programming.
♦ RS-232 port enabling the alarm system operation by means of a computer
(DLOAD64 installation programme), operation with a printer and the use of an
external modem.
♦ Pulse power supply of output load 3 A, with short circuit protection, provided with
battery monitoring and discharged battery disconnection unit.
♦ Independent real time clock with calendar, provided with its own back-up battery.
♦ Visual signalling of operations of all outputs, battery charging circuit and
telephone communication unit.
♦ Protection of all inputs, outputs and communication buses.
LCD keypad
♦ Large, well-readable display 2x16 characters with permanent or temporary display
backlit after pressing the key or activated with any control panel zone.
♦ 16-key keyboard with backlit controlled as the display backlit.
♦ 2 zones with properties identical to main panel zones.
♦ Microswitch for controlling keypad tampering.
♦ RS-232 port allowing alarm system operation with by means of computer
(GUARD64 supervisory and user program – full monitoring of system status,
virtual keypad, facilitated management of users).
Partition keypad
♦ 12-key keypad with permanent or temporary backlit.
♦ 3 LEDs (ALARM, ARMED, FAILURE) for showing the status of partition to which
the keypad is assigned.
♦ Microswitch for controlling keypad tampering.
♦ Relay for control of electric catch, lock or electromagnetic interlock.
♦ NO/NC zone for door status monitoring.
Code lock
♦ 12-key keypad with permanent or temporary backlit.
♦ 3 LEDs, showing readiness, access allowed and, additionally, system failure.
♦ Microswitch for controlling code lock tampering.
♦ Relay for control of electric catch, lock or electromagnetic interlock.
♦ NO/NC zone for door status monitoring.