15.
CLUTCH ADJUSTMENT
The clutch pedal free-play should be 1.57 in. (40 mm)
at
A as shown
in
Fig. 44. The free-play
is
very important
to
keep
the
correct free
travel of
the
clutch release thrust bearing.
The pedal free-play
is
locked by
:One'
turn
unscrewing
the
adjustiri~~lt
8 from the position where
the
bolf1s.contacted with the pedal
hang-ef.,D,
after depressing the pedal.
Fig.
44
Clutch
Pedal
16.
CENTER BEAM AND FRONT HUB
page 34
The center beam pin
is
always loaded, therefore,
the
A portion as
shown
in
Fig.
45
should
be
greased. For
other
greasing, refer
to
Greasing Chart
of
SECTION 2 REGULAR MAINTENANCE.
If
the
front axle shows excessive wear because of lack of periodical greasing,
consult
your
SA
TOH dealer.
The front hub
is
greased when
the
tractor
is
assembled
in
the
factory,
and
the
preload
of
the
bearing
is
also set
at
the same time. Every 500
hours of operation, they should be checked.
If
necessary, the grease
should be replaced and
the
preload be readjusted. To adjust
the
preload, screw
in
the slotted
nut
up
to
a slightly seated position, then,
screw out by 1/8....,
1/16
turn.
Loc~
it with a
cotter
pfn.
Note: For this adjustment, jack up
the
front
wheels.
To Next Page
Loading...