-
SECTION
1.
OPERATION
STARTING
AND
STOPPING THE
ENGINE
Before starting
the
engine, be sure to check
the
engine oil, cooling
water, transmission
oil
and hydraulic
oil
for quantity,
in
addition
the
daily check specified
in
1-1
of
SECTION
2-
(
1)
The engine
is
provided with a safety switch, so
that
the starter will
not run excepting when
the
range lever
is
in
"NEUTRAL"_
Accordingly, when starting the engine, place range lever
in
"NEUTRAL".
(
2)
Set
the
starter switch
to
"0
N", and confirm
the
oil
pressure
warning lamp, battery charge warning lamp, and water temperature
warning lamp. Turn the starter switch
to
"START",
then,
the
engine will start
to
run. After
the
engine has been started, keep off
your hand from
the
starter switch.
Fig. 4
(3)
Avoid turning
the
starting motor for 15 consecutive seconds or
more.
(4)
U"nder
the cold climate, disengage
the
clutch by fully depressing
the
pedal, then, fully pull
out
the choke button.
Start
the
engine
with
the
throttle
lever in
the
idle running speed.· After
the
engine
started, release
the
clutch pedal and slowly push in the choke lever
while observing
the
engine condi.tion. When
the
engine started
to
run smoothly, keep
the
engine under idle running for warming-up.
(5)
To
stop
the
engine,
turn
the throttle lever
to
the
"SLOW" (idle
running) position, and
set
the
starter switch
to
"OFF".
After stopping, be sure
to
remove the main switch key.
page 5
To Next Page
Loading...
Need help?
General
