Taillamps, Turn Signal, Stoplamps
and Back-up Lamps
To replace one of these bulbs, do the following:
1. Remove the taillamp fasteners from the body of
the vehicle.
2. Slide the taillamp
housing rearward and
away from the body
of the vehicle.
3. Disconnect the taillamp housing electrical connector
and remove the taillamp housing.
4. Turn the bulb socket being replaced
counterclockwise to disconnect it from the
taillamp housing.
5. Pull the bulb out of the bulb socket.
6. Push the new bulb into the bulb socket.
7. Reverse Steps 1 through 3 to reinstall the taillamp
assembly.
5-59
To Next Page
Need help?
General
