Using the Tire Sealant and Compressor
Kit without Sealant to Inflate a Tire
(Not Punctured)
To use the air compressor to inflate a tire with air only
and not sealant:
Always do a safety check first. See If a Tire Goes Flat
on page 5-72.
1. Remove the tire sealant and compressor kit from its
storage location. See Tire Sealant and Compressor
Kit Storage on page 5-92.
2. Unwrap the air only hose (G) and the power plug (H).
3. Place the kit on the ground.
4. Remove the tire valve stem cap from the flat tire by
turning it counterclockwise.
5. Attach the air only hose (G) onto the tire valve stem
by turning it clockwise until it is tight.
6. Plug the power plug (H) into the accessory power
outlet in the vehicle. Unplug all items from other
accessory power outlets. See Accessory Power
Outlet(s) on page 3-14.
If the vehicle has an accessory power outlet,
do not use the cigarette lighter.
If the vehicle only has a cigarette lighter,
use the cigarette lighter.
Do not pinch the power plug cord in the
door or window.
7. Start the vehicle. The vehicle must be running
while using the air compressor.
8. Turn the selector switch (A) clockwise to
the Air Only position.
9. Press the on/off (B) button to turn the
compressor on.
The compressor will inflate the tire with air only.
5-90
To Next Page
Loading...
Need help?
General
