To return the seat to the sitting
position:
1. Make sure the safety belt is
through the storage clip.
2. Lift the seatback and push it
rearward until it is locked in
the sitting position.
3. Push and pull on the seatback to
make sure it is locked.
4. Remove the safety belt from the
storage clip.
The seatback must be locked or
you will not be able to pull out
and use the rear center safety
belt. Always push and pull on the
seatback to be sure it is locked.
Safety Belts
This section of the manual describes
how to use safety belts properly.
It also describes some things not
to do with safety belts.
{ CAUTION
Do not let anyone ride where he
or she cannot wear a safety belt
properly. If you are in a crash
and you are not wearing a safety
belt, your injuries can be much
worse. You can hit things inside
the vehicle harder or be ejected
from it and be seriously injured
or killed. In the same crash, you
might not be, if you are buckled
up. Always fasten your safety
belt, and check that your
passenger(s) are restrained
properly too.
1-8 Seats and Restraints
To Next Page
Loading...
Need help?
General
