Emissions Inspection and
Maintenance Programs
Some state/provincial and local
governments have or might begin
programs to inspect the emission
control equipment on your vehicle.
Failure to pass this inspection
could prevent getting a vehicle
registration.
Here are some things to know to
help the vehicle pass an inspection:
• The vehicle will not pass this
inspection if the check engine
light is on or not working properly.
• The vehicle will not pass this
inspection if the OBD (on-board
diagnostic) system determines
that critical emission control
systems have not been
completely diagnosed by the
system. The vehicle would
be considered not ready for
inspection. This can happen
if the battery has recently been
replaced or if the battery has
run down. The diagnostic system
is designed to evaluate critical
emission control systems during
normal driving. This can take
several days of routine driving.
If this has been done and the
vehicle still does not pass the
inspection for lack of OBD system
readiness, your dealer/retailer can
prepare the vehicle for inspection.
Oil Pressure Light
{ CAUTION
Do not keep driving if the oil
pressure is low. The engine can
become so hot that it catches
fire. You or others could be
burned. Check the oil as soon
as possible and have the
vehicle serviced.
Notice: Lack of proper engine oil
maintenance may damage the
engine. The repairs would not be
covered by the vehicle warranty.
Always follow the maintenance
schedule in this manual for
changing engine oil.
This light comes on briefly when the
ignition is turned on as a check to
be sure it works. If it does not, have
the vehicle serviced.
If the light comes on and stays on, it
means that oil is not flowing through
the engine properly. The vehicle
could be low on oil and might have
some other system problem.
4-22 Instruments and Controls
To Next Page
Loading...
Need help?
General
