To return the seat to the sitting
position:
1. Make sure the safety belt is
through the storage clip.
2. Lift the seatback and push it
rearward until it is locked in
the sitting position.
3. Push and pull on the seatback to
make sure it is locked.
4. Remove the safety belt from the
storage clip.
The seatback must be locked or you
will not be able to pull out and
use the rear center safety belt.
Always push and pull on the
seatback to be sure it is locked.
Safety Belts
This section of the manual describes
how to use safety belts properly.
It also describes some things not to
do with safety belts.
{ CAUTION
Do not let anyone ride where a
safety belt cannot be worn
properly. In a crash, if you or your
passenger(s) are not wearing
safety belts, the injuries can be
much worse. You can hit things
inside the vehicle harder or be
ejected from the vehicle. You and
your passenger(s) can be
seriously injured or killed. In the
same crash, you might not be, if
you are buckled up. Always fasten
your safety belt, and check that
your passenger(s) are restrained
properly too.
1-8 Seats and Restraints
To Next Page
Loading...
Need help?
General
