Notice: If an improper coolant
mixture is used, the engine could
overheat and be badly damaged.
The repair cost would not be
covered by the vehicle warranty.
Too much water in the mixture
can freeze and crack the engine,
radiator, heater core, and
other parts.
Notice: If you use extra
inhibitors and/or additives in
your vehicle’s cooling system,
you could damage your vehicle.
Use only the proper mixture of
the engine coolant listed in
this manual for the cooling
system. See Recommended
Fluids and Lubricants in the
Maintenance and Limited
Warranty and Owner Assistance
Information manual.
Checking Coolant
The coolant reservoir is located in
the engine compartment on the
driver’s side of the vehicle.
See Engine Compartment Overview
on page 9-6 for more information
on location.
{ CAUTION
Turning the coolant reservoir
pressure cap when the engine
and radiator are hot can allow
steam and scalding liquids to blow
out and burn you badly. Never
turn the coolant reservoir pressure
cap – even a little – when the
engine and radiator are hot.
The vehicle must be on a level
surface. When your engine is cold,
the coolant level should be at
the KALT/COLD line.
Do not overfill the coolant reservoir.
Too much coolant can result in
an overflow condition when the
fluid is hot.
Vehicle Service and Care 9-17
To Next Page
Loading...
Need help?
General
