blinks when selecting
Room Temp. Mode
When blinks, set the desired
heating temp. between 10~40丯 by
adjusting +/- button, after a while,
it is automatically saved.
Heating temp. can be set by 1丯.
After the setting is done,
is on and current room temp.
is displayed.
If a room thermostat is programmed with Room Temp. Mode
and it is placed in the following places when using Room Temp.
mode, it may cause some errors to recognize temperature.
1. Frequently opened and closed door and drafty place.
2. A place where direct sunlight is eected and high humidity.
3. A place under direct inuence from heat, such as radiator.
In that case, Heating Water Temp. is recommended.
Press the Mode button repeatedly,
until is displayed.
Set the heating temp.
with +/- button.
CAUTION
Room Temp. Mode
13
To Next Page
Loading...