Preparation and checking before starting to operate
Now press the power button on the panel
repeatedly, and the oil ows out.
Lock the valve and press the power button
again, and the boiler gets ignited.
In case that after removing air completely,
the igni-tion has failed repeatedly about
three times, contact the sales agency or the
commercial agency.
Open the drain valve, and check out whether
there is water in.
Check out whether the pipes is lled with water.
Check out that the boiler is grounded to
earth. (Don’t ground to the gas pipe or
a lightening conductor)
Plug the power plug in the outlet.
(Checking if the outlet power is 220V)
Press the power button, and check out if
“RUN” lamp turns on a little later.
8
To Next Page
Loading...