JOBNAME: 1st Edition PAGE: 45 SESS: 1 OUTPUT: Tue Jul 24 09:46:13 2007
2. Locate the aim dot on the lens of the low-beam
headlamp.
3. Measure the distance from the ground to the aim
dot on the low-beam headlamp. Record the
distance.
4. At the wall measure from the ground upward (A) to
the recorded distance from Step 3 and mark it.
5. Draw or tape a horizontal line (B) on the wall the
width of the vehicle at the height of the mark in
Step 4.
Notice:
SIO-ID=817567 LMD=13-sep-2002 Do not cover a
headlamp to improve beam cut-off when aiming.
Covering a headlamp may cause excessive
heat build-up which may cause damage to the
headlamp.
6. Turn on the low-beam headlamps and place a
piece of cardboard or equivalent in front of the
headlamp not being adjusted. This allows only the
beam of light from the headlamp being adjusted
to be seen on the flat surface.
1756669
1656201
289
2008 - Saturn VUE Owner Manual (July 23, 2007)
To Next Page
Loading...
Need help?
General
