Sauder 158085 - Page 28

9
158085
www.sauder.com/services
BLACK 1--7/8” FLAT HEAD SCREW
(2 used for the SKIRT)
SKIRT (N)
Unfinished
surface
BOTTOM
MOLDING (L)
Flat
surface
Rounded
edge
- Fasten the SKIRT (N) to the BOTTOM MOLDING (L) as shown in the upper diagram. Use two BLACK 1--7/8”
FLAT HEAD SCREWS through the BOTTOM MOLDING and into the pre--drilled holes in the SKIRT.
NOTE: Be sure the flat surface and rounded edge of the BOTTOM MOLDING are facing as shown. Be
sure the unfinished surface of the SKIRT is positioned as shown. Follow the diagram.
- Fasten the BOTTOM MOLDING (L) to the BOTTOM (E) as shown. Use three BLACK 1--1/8” PAN HEAD
SCREWS through the BOTTOM MOLDING and into the pre--drilled holes in the BOTTOM.
NOTE: Be sure the rounded edge of the BOTTOM MOLDING is facing up as shown. Follow the
diagram. Do not
overtighten the SCREWS.
- Carefully turn a FOOT SCREW (S) a few turns into the two holes shown in the BOTTOM MOLDING (L).
- Next, turn a FOOT (T) onto the other end of each FOOT SCREW (S). Turn the FEET clockwise until the FOOT
SCREW is tight in the BOTTOM MOLDING and each FOOT.
NOTE: Do not
overtighten the FOOT SCREWS.
FOOT (T)
FOOT
SCREW (S)
Rounded
edge
BOTTOM
MOLDING (L)
BOTTOM (E)
BLACK 1--1/8” PAN HEAD SCREW
(3 used in this step)