Sauder 158085 - Page 27

8
158085
www.sauder.com/services
BLACK 9/16” LARGE HEAD SCREW
(6 used in this step)
RIGHT
END (A)
LEFT
END (B)
SHORT END
MOLDING (I)
- Fasten the SHORT END MOLDINGS (I) to the ENDS as shown. Use a BLACK 9/16” LARGE HEAD SCREW
through the six ANGLE BRACKETS andintotheSHORT END MOLDINGS.
NOTE: The SHORT END MOLDINGS should be against the SHELF MOLDING (K).
NOTE: Be sure the grooves in the END MOLDINGS are positioned as shown. Follow the enlarged
diagram closely.
The SHORT END
MOLDINGS should
be against the SHELF
MOLDING (K).
SHELF
MOLDING (K)