Sauder 158085 - Page 4

AUDER WELCOMES YOU TO THE WORLD OF READY-- TO--ASSEMBLE FURNITURE
SSEMBLY IS QUITE SIMPLE IF YOU FOLLOW OUR STEP--BY --STEP INSTRUCTIONS
NPACK PARTS CAREFULLY TO PREVENT SCRATCHING OF THE FINISHED PIECES
O NOT BEGIN ASSEMBLY UNTIL YOU ARE FAMILIAR WITH THE PARTS
XTRA TIME SPENT DURING THE ASSEMBLY WILL BE WELL WORTH IT
EADY....SET....GO
S
A
U
D
E
R
CFCs
The polystyrene foam used in Sauder
packaging contains no CFCs
which
are known to reduce stratospheric
ozone layers.
158085
Each time a screw is used, it is shown actual
size for you to compare with the screw in
your hand. You may receive some extra
hardware. This is done to assure you receive
at least the amount required.
(X) BLACK 1--7/8” PAN HEAD SCREW -- 3
(CC) BLACK 1--1/8” PAN HEAD SCREW -- 3 (AA) BLACK 9/16” LARGE HEAD SCREW -- 36
ASSEMBLY TOOLS REQUIRED
HAMMER
NO. 2 PHILLIPS SCREWDRIVER
TIP SHOWN ACTUAL SIZE
-- -- -- -- -- -- -- -- -- S C R E W S S H O W N A C T U A L S I Z E -- -- -- -- -- -- -- -- --
IMPORTANT
Using a SCREW that is too long will cause damage to your unit. Before beginning
assembly, you should separate each type of SCREW. Carefully study the SCREW
diagrams below. Pay close attention to the color of each SCREW.
1
(BB) NAIL -- 41
(Y) BLACK 1--7/8” FLAT HEAD SCREW -- 2