2
Read each step through completely before beginning the step. This box “-” is provided as a check--off box. As you
complete each task, check it off. Assemble your unit on a carpeted floor or on the empty carton to avoid scratching
the finished surfaces.
- To begin assembly, push a SAUDER TWIST-LOCK
R
FASTENER (V) into the large holes in the RIGHT END (A)
and LEFT END (B). Repeat this step for the SHELF (D) and BOTTOM (E).
NOTE: Be sure the TWIST-LOCK
R
FASTENERS are positioned as shown in the enlarged diagrams.
Make sure the point is positioned as shown in the enlarged diagram. Do not
tighten the
TWIST-LOCK
R
FASTENERS at this time.
NOTE: If you need to remove a TWIST-LOCK
R
FASTENER from a hole, pull the FASTENER back out
of the hole. Pull at the front and back edges, slowly working the FASTENER out of the hole.
158085
Make sure this point
is in this location.
Dowel end
TWIST-LOCK
R
FASTENER (V)
LEFT
END (B)
RIGHT
END (A)
www.sauder.com/services
To Next Page
Loading...
