5
158085
Follow the diagrams closely for this step. Be sure the parts are positioned as shown.
How to use the SAUDER TWIST-LOCK
R
FASTENER (Refer to th e enlarged diagram.)
1. Insert the dowel end of the FASTENER into the hole of t he adjoining part.
NOTE: The dowel end of the FASTENER must remain fully inserted in the
hole of the adjoining part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight as possible.
You may notice a separation of the plastic and a “popping” noise while
tightening the FASTENER. These are both intended design features.
- Position the TOP (C) as shown.
NOTE: Be sure the long finished edge is facing up.
- Fasten the RIGHT END (A) to the TOP (C). Tighten the TWIST-LOCK
R
FASTENERS in the RIGHT END.
NOTE: Be sure the finished edge of the RIGHT END is facing up.
- Fasten the SHELF (D) and BOTTOM (E) to the RIGHT END (A). Tighten the TWIST-LOCK
R
FASTENERS in
the SHELF and BOTTOM.
NOTE: Be sure the indicated holes are in the location shown. Follow the diagram.
For assembly tips involving
this step, visit our web site
at: www.sauder.com/tips
TOP (C)
RIGHT
END (A)
SHELF (D)
BOTTOM (E)
Tighten the FASTENER as tight
as possible after
inserting the
dowel end of the FASTENER into
the hole of the adjoining part.
Long
finished
edge
These holes
should be here.
www.sauder.com/services
To Next Page
Loading...
