Sauder 401291 - Page 17

Step 12
å
Insert four METAL PINS (JJ) into the ends of the DIVIDER (D451).
å
Insert the METAL PINS (JJ) in one end of the DRAWER DIVIDER (D451)
into the holes in the SMALL DRAWER FRONT (L2).
å
Fasten the SMALL DRAWER BACK (D450) to the SMALL DRAWER
SIDES (D245 and D271) and DRAWER BRACE (M64). Use five BLACK
1-9/16" FLAT HEAD SCREWS. (30S).
å
NOTE: Be sure the METAL PINS in the DRAWER DIVIDER insert into
the SMALL DRAWER BACK.
401291www.sauder.com/services
Pae 17
Finished ede
JJ
(4 used)
D451
D450
L2
D271
D245
M64
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK roove.
Start each screw a few turns before
completely tihtenin any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(5 used in this step)
30S