Sauder 402159 - Step 9: Securing Right Braces and Bases

å
Insert four CAMS (P1) into the BRACES (L).
å
Fill the holes in the RIGHT END (F) and RIGHT
UPRIGHT (E) a 1/4 to 1/2 full with GLUE (G1)
as shown.
å
Fasten the BRACES (L) to the RIGHT UPRIGHT (E)
and RIGHT END (F). Tighten four CAMS (P1).
å
NOTE: Be sure the DOWELS in the ends of the
BRACES insert into the END and UPRIGHT. Wipe
away the excess glue.
å
Fasten two BASES (G) to the BRACES (L). Use
four BLACK 1" PAN HEAD SCREWS (S3).
Step 9
E
E
F
F
G
G
L
L
L
L
P1
P1
Arrow
Arrow
Curved edge
Curved edge
Page 13
www.sauder.com402159
Inspect the parts thoroughly before
assembling. Disassembly of glued
parts is extremely di cult.
Caution
!
BLACK 1" PAN HEAD SCREW
(4 used in this step)
S3
3
21
P1
The arrow must
point toward the
edge of the board
G1
G1