å
Make equal margins along all four edges of the BACKS (I
and J). Push on opposite corners of your unit if needed to
make it "square".
å
Fasten the BACKS (I and J) to your unit using the NAILS (HHH).
å
NOTE: Be sure to tap NAILS into the holes that line up over
the BOTTOMS (G2 and H).
Step 5
402375 www.sauder.com/servicesPage 10
Finished
surface
Finished
surface
G2
H
J
I
These edges must be even.
These holes must line up
over the BOTTOM (H).
These holes must line up
over the BOTTOM (G2).
NAIL
(29 used in this step)
HHH
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
To Next Page
Loading...
