Step 3
419321www.sauder.com/services
Page 7
å
Fasten the LEFT END (B) to the TOP (E). Tighten two
TWIST-LOCK® FASTENERS.
Dowel end
How to use the SAUDER TWIST-LOCK
®
FASTENER
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
Surface with
TWIST-LOCK®
FASTENERS
B
J
E
Surface
with holes
Long fi nished edge
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
To Next Page
Loading...
