Sauder 419954 - Step 10

Step 10
419954 www.sauder.com/servicesPae 14
å
Separate the WIDE EXTENSION SLIDES (Z) from the WIDE EXTENSION RAILS (Y) as shown in the upper diaram below.
Be prepared, the parts are reasy.
å
Fasten the WIDE EXTENSION RAILS (Y) to the ENDS (A and B) and UPRIGHTS (D and E). Use eiht GOLD 5/16" FLAT
HEAD SCREWS (3S) throuh holes #1 and #3.
å
NOTE: For each WIDE EXTENSION RAIL, turn a SCREW into the hole shown in the enlared diaram. Then, slide the inner
cartride of the WIDE EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the ENDS and UPRIGHTS.
Turn a SCREW into this hole.
å
NOTE: The WIDE EXTENSION SLIDES will be used later for the LARGE DRAWERS.
Open end
Open end
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
3S
Open end
A
B
E
D
Y
Y
Y
Y
YZ
Ede with
TWIST-LOCK®
FASTENERS
Ede with
TWIST-LOCK®
FASTENERS
Surface with
TWIST-LOCK®
FASTENERS
Surface with
TWIST-LOCK®
FASTENERS
Surface with
TWIST-LOCK®
FASTENERS
Surface with
TWIST-LOCK®
FASTENERS
Open end
Separate the WIDE EXTENSION SET (Y and Z)
from the NARROW EXTENSION SET (AA and BB).
P
H
P
H
Ede with
TWIST-LOCK®
FASTENERS
1
3
2
4
1
3
2
4
1
3
2
4
1
3
2
4