Sauder 421952 - Final Assembly and Finishing

å
Fasten twelve METAL BRACKETS (4G) to the BOTTOM (E).
Use twelve BLACK 9/16" LARGE HEAD SCREWS (1S).
å
NOTE: Be sure four of the BRACKETS are even with the
SHORT edges of the BOTTOM.
å
Fasten the SKIRTS (H and I) to the BOTTOM (E). Use twelve
BLACK 9/16" LARGE HEAD SCREWS (1S) through the
BRACKETS and into the SKIRTS.
å
NOTE: There are no pre-drilled holes in the SKIRTS. The
SCREWS will tighten into the grooves.
Step 11
421952www.sauder.com/service
Page 15
BLACK 9/16" LARGE HEAD SCREW
(24 used in this step)
1S
4G
4G
4G
4G
E
I
H
H
I
The groove
is closer to
this edge.
The groove
is closer to
this edge.
(12 used)