å
Unfold the BACK (D) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (D).
Push on opposite corners of your unit if needed to make it
"square".
å
Fasten the BACK (D) to your unit using the NAILS (4). The
NAILS should be 4" apart and 1/4" in from the edges.
Step 6
NAIL
(52 used in this step)
4
D
Unfinished
surface
8
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
4"
1/4"
Page 10 www.sauder.com/service 426928
To Next Page
Loading...
