å
Carefully stand your unit upright.
å
Open the FURNITURE TIPPING RESTRAINT KIT (98) and fasten the SAFETY STRAP to the FIXED SHELF (E) shown.
Use the provided short screw.
å
Place your unit in its final location against a wall. Locate the center of a stud in your wall near your unit and mark it
with a pencil. Next, drill a 1/8" hole on the mark and into the stud in your wall.
å
Fasten the unit to the wall. Use the long screw through the other end of the strap and into the 1/8" hole.
Step 10
98
98
Electric drill with 1/8" bit
(ONLY in indicated step)
Drill 1/8" hole into
a stud in your wall.
Page 14 www.sauder.com/service 426932
E
Use the short screw through
the hole in the strap and into
the top surface of the
FIXED SHELF (E).
To Next Page
Loading...
