Sauder 429430 - Step 8: Back Panel and Felt Disc Installation

Step 8
å
Carefully turn your unit over onto its front edges. Unfold
the BACK (M) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (M).
Push on opposite corners of your unit if needed to make
it "square".
å
Using your hammer, fasten the BACK (M) to your unit
using the NAILS (12).
å
NOTE: Be sure to tap NAILS into the holes that line up
over the UPRIGHT (C).
å
Peel the backing o of each FELT DISC (20) and stick
them on the edge of the ENDS (A and B).
å
NOTE: Be sure the FELT DISCS are placed approximately
1/8" in from the front edge of the ENDS.
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
NAIL
(36 used in this step)
12
M
Unifinished
surface
These holes must line up
over the UPRIGHT (C).
A
B
20
This FELT DISC should set in 1/8"
from the front edge of the ENDS.
This FELT DISC should set in 1/8"
from the front edge of the ENDS.
8
This arrow should
be pointing up.
UP
Page 12 www.sauder.com 429430 / 168-0094-8