Step Step 12
å
Place your unit in its final location.
å
1
st
- Use the FURNITURE TIPPING RESTRAINT KIT (96) for added stability. Fasten the SAFETY STRAP to the TOP (D)
using the SHORT SCREW.
å
The following instructions show your unit being fastened to a wall stud. If you are not fastening your unit to a wall stud,
go to the next step now.
å
2
nd
- Locate the center of a stud in your wall near your unit and mark it with a pencil.
å
3
rd
- Drill a 1/8" hole on the mark and into the stud in your wall.
å
4
th
-
Fasten the unit to the wall. Use the LONG SCREW through the other end of the SAFETY STRAP and into the 1/8" hole.
D
96
Electric drill with 1/8" bit
3
rd
Use the short screw through the hole
in the strap and into the TOP (D).
1
st
4
th
Mark and drill
a 1/8" hole into
the wall stud.
2
nd
FRFRONTONT
Page 16 www.sauder.com 429430 / 168-0094-8
To Next Page
Loading...
