å
Carefully turn your unit over onto its front edges. Unfold one of
the BACKS (I) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (I). Push
on opposite corners of your unit if needed to make it "square".
å
Fasten the BACK (I) to your unit using the NAILS (1N). Do not
fasten the edge that lays over the UPRIGHT.
å
Next, fasten the other BACK (I) to your unit using the NAILS.
The BACKS will overlap each other. See the enlarged diagram.
å
NOTE: Be sure to tap NAILS into the holes that line up over the
UPRIGHTS (D and E) and SHELVES (H).
Step 11
414726www.sauder.com/services
Page 15
I
I
These holes must line up over
the UPRIGHTS and SHELVES.
I
I
Unfi nished
surface
Unfi nished
surface
NAIL
(91 used in this step)
1N
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
To Next Page
Loading...
