Sauder Carson Forge 415520 - Page 15

å
Carefully turn your unit over onto its front edes. Unfold the
BACK (F) and lay it over your unit.
å
Make equal marins alon all four edes of the BACK (F). Push
on opposite corners of your unit if needed to make it “square”.
å
Fasten the BACK (F) to your unit usin the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
the UPRIGHT (C).
å
NOTE: The cut out squares must be toward the TOP (D).
Step 10
415520www.sauder.com/services
Pae 15
Do not stand the unit upriht without the
BACK fastened. The unit may collapse.
Caution
These holes must line up
over the UPRIGHT (C).
NAIL
(48 used in this step)
1N
D
F
Cut-out square