Sauder Carson Forge 415520 - Page 9

å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into
the ENDS (A and B) until the shoulder of the SCREWS
rest on the surface of the ENDS.
å
Slide the END MOLDINGS (O) onto the ENDS (A and B).
Line up the roove in the MOLDINGS over the head of the
SCREWS in the ENDS.
Step 4
415520www.sauder.com/services
Pae 9
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
32S
These edes
should be even.
These edes
should be even.
Shoulder
Apply pressure with your hands
as you uide the MOLDINGS over
the SCREWS and onto the ENDS.
A
B
O
O
Surface without
HIDDEN CAMS
Surface without
HIDDEN CAMS