Sauder Carson Forge Armoire - Step 12: Back Panel Attachment

å
Carefully turn your unit over onto its front edes. Unfold
the BACK (F) and lay it over your unit.
å
Make equal marins alon all four edes of the BACK (F).
Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the BACK (F) to your unit usin the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
over the SHELF (E).
Step 12
Do not stand the unit upriht without the
BACK fastened. The unit may collapse.
Caution
415107www.sauder.com/services
Pae 17
F
Unfi nished surface
These holes must line
up over the SHELF (E).
NAIL
(47 used in this step)
1N
Printed
information
must be
facin up.