Sauder Carson Forge Armoire - Page 19

Step 14
BLACK 1-1/8" MACHINE SCREW
(2 used in this step)
21S
52K
A2
B2
H
P
415107www.sauder.com/services
Pae 19
å
Carefully stand your unit upriht.
å
Set the ROD (P) onto the ROD HANGERS on
the ENDS (A2 and B2).
å
Before fastenin the DOOR to your unit, be sure the
mountin screw is aainst the stops as shown in the
diaram. If it isn't, loosen the mountin screw to slide it
aainst the stops. Then tihten the mountin screw.
å
Fasten a DOOR (H) to the LEFT END (B2). Use the screws
in the HINGES.
å
Fasten a PULL (52K) to the DOOR (H). Use a BLACK 1-1/8"
MACHINE SCREW (21S).
å
Repeat this step for the other door.
Stop
Hine
Mountin
screw