å
Carefully turn your unit over onto its front edges. Unfold
the BACK (E) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (E).
Push on opposite corners of your unit if needed to make
it "square".
å
Fasten the BACK (E) to your unit using the NAILS (1N).
å
NOTE: Perforations have been provided for access
through the BACK. Carefully cut out the holes needed.
Step 7
411591www.sauder.com/services
Page 11
E
NAIL
(30 used in this step)
1N
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
To Next Page